Order Gravel, Stone and Soil in Kettle Falls, WA

Washington Rock Supply handles gravel and aggregate delivery in Kettle Falls, WA. Start on any product page, use the calculator to size your load, and order by the ton or the yard.

Most ground here is thin stony soil over bedrock on the ridges, with till and silt filling the valleys.

That mix is why 5/8 minus does so much work in this market. It is crushed rock with the fines left in, so it packs hard and sheds water instead of soaking it up.

Delivery to Kettle Falls and the Surrounding Area

You order online and a dump truck tips the load on your site. Pick the quantity in tons or yards, then choose a delivery date at checkout.

The driver leaves the pile where the truck can reach, and that is the whole handoff.

Kettle Falls sits in Stevens County, and delivery covers the surrounding area. We also run loads to Colville, Chewelah, Loon Lake, Springdale, and Northport.

If you are building or repairing anywhere in this corner of the county, the order goes through the same checkout.

Bulk loads are heavy, so it helps to know where the truck can turn around before you order. Size the material on the calculator so the pile matches the job.

Materials for Kettle Falls Projects

Fill and sub-base do the heavy lifting on most sites around here, because so many lots need grade raised before anything else goes down. Build up the low spots with Fill Dirt, which is common borrow, then cap it with a granular course.

The difference matters: gravel borrow is the structural fill, and common borrow is not.

For a building pad, a shop slab, or a parking area, the structural layer is 1 1/4 Minus, also called CSBC. It carries load and stays workable on soft spring ground.

On top of that goes 5/8 Minus, the CSTC course this market calls for. Fines left in means it compacts and holds.

Long rural drives and equipment parking take Driveway Gravel, a blend sold alongside the graded surfacing courses. Where water needs to move instead of sit, Drain Rock is the washed 7/8 clean stone for footing drains and French drains.

For the finish work: Walkway Gravel, or 1/4 minus, packs tight underfoot on paths. Stone Screenings, also called crusher dust, beds pavers and flagstone.

Top Soil and Shredded Mulch finish lawns and beds.

Ground and Conditions in Kettle Falls

Across the Okanogan Highlands and the northeast corner, the ground runs to thin stony soil over granite, gneiss and metamorphic rock on the ridges. Till, outwash gravel and lake silt fill the valleys.

That valley till and silt is the part that catches people out, because it holds water instead of passing it.

Most of the year's water arrives as snow and leaves over a few weeks in spring. Snowmelt saturates valley soils while the ground below is still frozen, so gravel floors drain fast and till or silt floors do not.

An under-built base on that ground shows it quickly.

The working season is short. Base, drive and paver work fits between spring breakup and the autumn freeze, and the window narrows the higher and further north the site.

Eastern Washington's erosion control season runs October 1 through June 30.

This is the coldest corner of the state, with long winters and a slow breakup. Frost heave and soft spring ground govern any unbound base.

Frost depth in Okanogan County is 24 inches, and the building department sets the figure for your site.

Questions About Ordering in Kettle Falls

What is the best base under pavers in Kettle Falls?

Two layers work well. Put 1 1/4 Minus down as the structural course so the load spreads and the ground stays workable.

Top it with 5/8 Minus, which is crushed rock with the fines left in, so it packs hard and sheds water. Then bed the pavers in Stone Screenings, also called crusher dust, which compacts rather than drains.

For joints and thin beds where you want washed stone, use 3/4 clean instead.

Do you supply contractors working in Kettle Falls?

Yes. Contractors order the same way homeowners do: online, by the ton or the yard, with a delivery date chosen at checkout.

A dump truck tips the load on site as one pile. The calculator on each product page sizes the load, and you can order 1 1/4 Minus, 5/8 Minus, drain rock, crusher dust and the rest of the aggregate list for jobs anywhere in Stevens County.

Order 5/8 Minus for Your Kettle Falls Site

5/8 minus is the surfacing course this market builds on, and it is the one to start with when you are raising grade or laying in a pad. Washington Rock Supply delivers bulk gravel, stone, sand, topsoil and fill across Kettle Falls.

Pick your material, size the load with the calculator, and place your order online.